Skip to Content

Stop A Hardwired Smoke Detector Beeping

Stop A Hardwired Smoke Detector Beeping

If you came to this post looking to stop a hardwired smoke detector beeping then you came to the right place. Read on to find out all of the tips and tricks to stop the smoke detector from beeping.

In order to stop a hardwired smoke detector beeping you must unplug it from the clip and remove the battery. Sometimes The 9 Volt battery compartment is difficult to open. As a general rule these batteries should be changed once every six months.

Not all smoke detectors are the same, we will offer some helpful tips.

7 ways to stop a hardwired smoke detector beeping

  1. How to unplug the smoke detector from its socket
  2. How to remove the battery from its enclosure
  3. Smoke detector maintenance
  4. Where to buy the proper smoke detector
  5. Knowing when to change the batteries
  6. Best smoke detector brand to buy
  7. What to do if it just doesn’t stop beeping

1.Stop a smoke hardwired smoke detector beeping by unplugging its socket

On the back of the smoke detector there is a hardwired socket. To access this suck it must turn the smoke detector counter clockwise. If you turned the smoke detector and pull it down.

The socket on the back of the smoke detector will need to be squeezed with your two fingers to remove it from the back. This is the hard wired portion which attaches to the ceiling outlet.

Sometimes the sockets on the back of the smoke detector is difficult to remove . You may need to be forceful to remove the sockets. However under no circumstances should you pull the wiring out of the ceiling fixture.

When you look at the back of the smoke detector after you remove the socket . You will see it either has 3 pins or 4 pins. Make sure these pins do not get bent or damaged.

2.How to remove the battery from its enclosure

On the back of the smoke detector there is a battery compartment. You may need to use a small flat head screwdriver to open this compartment. Make sure you take note up the polarity of the 9 Volt battery when you remove it.

This should stop the beeping completely . When you install the new battery again take note of the polarity this is very important. Do not use cheap dollar store batteries. The battery should be replaced every 6 months.

Check with your local local building codes to find out how often you should change the batteries. If you forget to change the batteries the smoke detector will remind you. You will hear a short beep once every minute.

This will drive you completely crazy until you change the battery. If you have more than one smoke detector in your home. Then you should change them all at the same time.

3.Smoke detector maintenance

Every 6 months when you change the batteries. You should check for moisture on the back of the smoke detector. Also look for dust present.

Which is very important that you take note update expiring date on the smoke detector. You need to change the smoke detector before they expire date in order for a to work efficiently.

When it comes to a smoke detector this can be life or death. The smoke detector is your warning system in case there is a problem do you get out of the house.

4.Where to buy the proper smoke detector

There are many places to purchase a good quality smoke detector. Check for the proper CSA or your L approval ratings on the smoke detector before you purchase it.

You should always be looking for a smoke detector that hard wires with battery backup. Did you know that you can purchase a smoke detector that also detects CO 2 levels in your home.

If you were looking to purchase a smoke detector online . Here are some of the higher quality smoke detectors we recommend…

Or you can check out our website directly….

5.Knowing when to change the battery

Mostly all newer smoke detectors will warn you when it is time to change the battery. They will beep until you change them. As a standard practice you should always change your smoke detector batteries once every 6 months as well as check your fire extinguishers.

For good practice you should always change the smoke detector batteries within 6 months. This is a good habit to get into since your safety at stake.

6.Best smoke detector brand to buy

There are a number of smoke detector brands on the market . BRK smoke detector series and kidde smoke detector series or 2 of the most popular. If you wish to purchase the smoke detector online please click here. BRK smoke detector series also comes with advanced c02 sensing technology.

Other battery versions of smoke detectors are OK to use if you want to alert herself in areas of the home are you don’t think you will hear your main smoke detector.

Both brk and kidde so versions of the smoke detector.

7.What to do if it just doesn’t stop beeping

You would think this is where we tell you to smash the smoke detector with a hammer. However that would not be professional.

Who simply need to have patience with your smoke detectors and remember they are beeping to tell you to change the battery.

If the smoke detectors are continuously beeping due to being set off. Then you can simply press the hush button to silence a smoke detector for upto a minute.

This will give you a chance to open some windows to get air flow through the house in case you just set them off by burning toast.

8.How to stop a hard wired smoke detector from chirping with no battery in it

Hey hard wired smoke detector will continue to chirp if it is left plugged into the socket even though you remove the battery.

You will need to remove it from the socket altogether and unplug it in order for it to stop chirping.

While left plugged into 120 Volt the smoke detector will sense there is no battery and continue to chirp.

9.Why does the smoke detector keeps beeping even after I change the battery

The smoke detector will keep beeping even after you change the battery. This is to let you know that there are other smoke detectors attached to the circuit that you forgot to change the battery in.

Simply walk through the host and look for all of your smoke detectors And make sure you change the batteries.

Most newer homes have wired in smoke detectors with battery backup on every level an every bedroom.

This can result in a number of smoke detectors in the house.

10.Will I get a shock by unplugging my smoke detector

Generally no you will not get a shock by plugging the pin connector on the back of the smoke detector . However you do not feel safe doing this then please shut off the breaker circuit powering the smoke detector.

Since it is now code do you have the smoke detector circuit on the power panel not indicated in for it to be tired in with a lighting circuit. It may be somewhat difficult to find out which circuit it is on.

Since is it is mandated by code 4 to be on with the lighting circuit it would be safe to say that if you shut off the lighting circuit. Then you will be able to shut off the smoke detector circuit. The smoke detector has a green indicator light to show that it has 120 Volt. Look for the light to go out.

stop hard wired smoke detector beeping

11.Why does the smoke detector beep only once a day intermittently

The smoke detector will be once per day and sometimes more if the battery begins to get week. This is an indication but you need to change the battery.

In addition if the smoke detector becomes dusty. It will also cause it to beep periodically. You can help this problem by blowing the smoke detector off with compressed air.

12.Other kinds of smoke detectors

If you live in a commercial apartment building the chances are that your smoke detector is starting to the fire alarm system.

These kinds of smoke detectors look as someone different from a normal home smoke detector . They will have a do not paint note on them. And they will also set off the fire alarm when trip.

Sometimes the smoke detector can be tired im with a home security system . They look similar do the same kind of smoke detector you would find in a commercial building. The smoke detectors are somewhat less sensitive than your normal home smoke detector to eliminate nuisance calling.

You should not try to pull these down and change the batteries in them. They also look very similar to a heat detector. These are found both in commercial buildings and homes depending on the type of security system that you have.

stop a hard wired smoke detector beeping